|
Re: [Networker] Automating save set list?
2013-09-13 17:08:35
On 2013-09-13 06:44, bingo wrote:
I think it is pretty simple:
If you exclusively store the data you want to protect on specific volumes
you just need to define them in the save set list.
Volumes in the save set list?
It avoids complicated directives and new directories will automatically be
backed up as well.
How will NW know to send a new file system, that's not enumerated in the
save set list, to the correct tape or pool? If you don't have 'All'
listed, and you don't specify it, how will NW be able to back it up? Can
you provide an example of what you're talking about? I must be
completely missing the point here. I'm assuming that there are no
specific tapes that are dedicated to specific data, just pools, and any
given volume may not be reused. Even still, listing volumes in the save
set listing?
Thanks.
George
+----------------------------------------------------------------------
|This was sent by carsten_reinfeld AT avus-cr DOT de via Backup Central.
|Forward SPAM to abuse AT backupcentral DOT com.
+----------------------------------------------------------------------
--
George Sinclair
Voice: (301) 713-3284 x210
- The preceding message is personal and does not reflect any official or
unofficial position of the United States Department of Commerce -
- Any opinions expressed in this message are NOT those of the US Govt. -
|
|
|
