Re: [Veritas-bu] How to backup to multiple drives
2009-02-19 05:20:20
Look in NetBackup Admin Guide II in the chapter called 'Additional
configuration' -> Multiplexing.
It describes in detail how multiplexing works, how multiple backups are
written to one drive and when a 2nd drive will be used.
-----Original Message-----
From: veritas-bu-bounces AT mailman.eng.auburn DOT edu
[mailto:veritas-bu-bounces AT mailman.eng.auburn DOT edu] On Behalf Of
dferguson
Sent: 19 February 2009 00:20
To: VERITAS-BU AT mailman.eng.auburn DOT edu
Subject: [Veritas-bu] How to backup to multiple drives
I have a two drive library (msl 5000) with two LTO2 drives. When I
backup large data I would like it to split the data up and backup using
both drives. Is this a possibility? I've been googling and found
multiplexing and I think I have enabled multiplexing or the storage unit
and set Max concurent write drives to 2 and checked the enable
multiplexing box and set maximum streams per drive to 2. But my backup (
sent via command line) is still only using one drive.
Is there a point where NBU makes a decision on when to utilize the
second drive?
+----------------------------------------------------------------------
|This was sent by dferguson AT crossroads DOT com via Backup Central.
|Forward SPAM to abuse AT backupcentral DOT com.
+----------------------------------------------------------------------
_______________________________________________
Veritas-bu maillist - Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
_______________________________________________
Veritas-bu maillist - Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
|
|
|