[Veritas-bu] FYI: Netbackup 3.2 Installation problem
2000-07-14 08:03:27
Subject: |
[Veritas-bu] FYI: Netbackup 3.2 Installation problem |
From: |
David A. Chapa david AT datastaff DOT com |
Date: |
Fri, 14 Jul 2000 07:03:27 -0500 (CDT) |
I've always been a fan of tpconfig...rarely teach
vmconf. You know what you are getting with tpconfig
because the control is in your hands.
David
Quoting "Everett, Craig" <Craig_Everett AT intuit DOT com>:
> FYI:
> I just found out that using the vmconf script to
automatically install a
> robot during an initial Netbackup installation is at
best 50% successful on
> average. The script identifies robotic controllers
and drives and then adds
> them to your database for use with Netbackup. The
problem is that this
> script mismatches your drive numbers to drive paths
so that when you go to
> mount a tape for backup the drive automatically downs
itself. The robot
> will
> mount a tape in drive3 and it will actually be in
drive4.
>
> Solution: Don't use vmconf to automatically
install/configure a robot. It
> doesn't work properly. Support says it's supposed to
be fixed in 3.4 but
> I'm
> not holding my breath.
>
> Thanks,
>
> Craig Everett
> Intuit Inc,
> San Diego
> _______________________________________________
> Veritas-bu maillist - Veritas-
bu AT mailman.eng.auburn DOT edu
>
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-
bu
>
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
David A. Chapa 847 413 1144 p
Director of Technology 847 413 1168 f
DataStaff, Inc. http://www.datastaff.com
nbu-lserv AT datastaff DOT com majordomo AT datastaff DOT com
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
|
|
|