Re: [Networker] mminfo question
2007-07-31 17:51:00
Eureka! Sheesh! I didn't realize it was going to be that easy. :-)
Davina Treiber wrote:
George Sinclair wrote:
Is there a way I can specify not '%used=full' with mminfo?
I want to see all volumes in a particular pool that are still
appendable. I know I can used '%used<=100', or I can pipe it to
something like: grep -v " full ". Just curious if there was some
way to use '!%used=full', but that doesn't work, nor does '%used!=full'.
mminfo -q "pool=mypool,!full"
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the body of the email. Please write to
networker-request AT listserv.temple DOT edu if you have any problems with
this list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
--
George Sinclair - NOAA/NESDIS/National Oceanographic Data Center
SSMC3 4th Floor Rm 4145 | Voice: (301) 713-3284 x210
1315 East West Highway | Fax: (301) 713-3301
Silver Spring, MD 20910-3282 | Web Site: http://www.nodc.noaa.gov/
- Any opinions expressed in this message are NOT those of the US Govt. -
To sign off this list, send email to listserv AT listserv.temple DOT edu and type
"signoff networker" in the body of the email. Please write to networker-request
AT listserv.temple DOT edu if you have any problems with this list. You can access the
archives at http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|
|
|