Re: [Networker] Schedules using interval attribute
2003-07-22 05:11:08
The only way I think you can do this without having to create a new group,
would be to setup a "savegrp -l full groupname" cron job that runs just before
the next hour backup kicks of so that you get a "savegrp already running"
message
This is the only way I can figure this out. You make no mention what OS your
backup server is so if UNIX, run a crontab, or NT run at or task scheduler.
HTH
SSI
-----Original Message-----
From: Asher Frenkel [mailto:asher_f AT RAD DOT COM]
Sent: 22 July 2003 11:04
To: NETWORKER AT LISTMAIL.TEMPLE DOT EDU
Subject: [Networker] Schedules using interval attribute
Hi,
I have a group backing up incremental every hour using the group
interval attribute.
Is there a way to have a one full during that day without setting up a
different group?
Asher
--
Asher Frenkel
Unix System Administrator
RAD Data Communications Ltd.
asher_f AT rad DOT com
Phone: 03-7657544 FAX: 03-6496595
--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
|
|
|