NT scheduler install in V3R1
1998-02-12 19:38:38
I have about 25 installs of V2.1.06 client in place and have had them
in place for over a year. Originally they were OS/2, but I slowly
migrated them to NT. I thought it was great to be able to run ADSM
Scheduler as a service. The service was pretty easy to install.
I just upgraded one of my machines from V2.1.06 to V3.1.1. I
completely uninstalled the old version of the backup/archive client.
After I did the new install, I couldn't figure out how to install the
scheduler service. Why was the neat little menu option taken away.
Secondly, why did they take away the easy to use executible.
I had to fumble around trying to get the right parameters before I
could install the service even with the scarce help using the dsmcutil
executible. When I finally did get it installed I did not understand
that the service name I was giving would be what it would actually be
called. I thought it was asking for the service executible.
Consequently, my first attempt at installing the service ended up
being dsmcsvc in my services panel. Removing it was just as
difficult.
WHY????? That is my question. Why make it harder than in a previous
release.
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- NT scheduler install in V3R1,
David Killingsworth <=
- Re: NT scheduler install in V3R1, Eric van Loon
- Re: NT scheduler install in V3R1, Rui Malheiro
- Re: NT scheduler install in V3R1, Smith, Richard
- Re: NT scheduler install in V3R1, Cindy Cannam
- Re: NT scheduler install in V3R1, Jerry Lawson
- Re: NT scheduler install in V3R1, Cindy Cannam
- Re: NT scheduler install in V3R1, Andrew Raibeck
- Re: NT scheduler install in V3R1, Prather, Wanda
- Re: NT scheduler install in V3R1, Jerry Lawson
- Re: NT scheduler install in V3R1, Pete Tanenhaus
|
|
|